ASSEMBLY
Attachment Clips
1. To attach the Pasta
Machine to the table or
countertop position the
Pasta Machine near the
edge of the work surface.
Pasta Machine Attachment
Attachment Clips
Traditional Style
Pasta Machine Attachments
Pasta Machine
Attachment Drive Hole
ALL SOLD SEPARATELY
2. Silde the C-Clamp into
the C-Clamp Hole in the
side of the Pasta Machine
.
Roller Drive
Hole
Traditional Style Pasta Machine
Square Ravioli Attachment (50mm)
Angel Hair Attachment (1mm)
Spaghetti Noodle Attachment (2mm)
Linguini Attachment (3mm)
01-0201
01-0209
01-0202
01-0203
01-0204
01-0206
Handle
3. Tighten the screw on
the C-Clamp to secure the
Pasta Machine to the table
or countertop.
Lasagna Attachment (50mm wide)
Lasagnette Attachment (12mm wide) 01-0205
Half Moon Ravioli Attachment (50mm) 01-0208
C-Clamp Hole
4. Slide
the
Cutter
C-Clamp
Attachment onto the
attachment clip of the
Pasta Machine.
These products and many more products can be ordered by visiting
W e s t o n P r o d u c t s . c o m or by calling
Weston Products LLC Toll Free at 1-800-814-4895
Monday thru Friday 8:00am-5:00pm EST. Outside the U.S. call 440-638-3131
5. Slide the Handle into the Drive Hole of the Roller or the Attachment to be used.
Be sure to notice when the Handle turns, it passes below the edge of the work surface
and turns freely.
Specific instructions on the use of each Pasta Machine Attachment is included in
the Pasta Machine Instruction Book.
For questions or further instructions, contact
Weston Products at 1-800-814-4895.
CLEANING
The Pasta Machine Attachments may have some excess oil on it from the factory. This
is to protect the machine during shipping. THIS OIL MUST BE REMOVED BEFORE
USING THE MACHINE!
ATTENTION!
If any components of this unit are broken, do not operate properly, or for product returns, please
contact Weston Products LLC
Phone: 1-800-814-4895 (Outside the U.S. 440-638-3131)
20365 Progress Drive, Strongsville, Ohio 44149
.
Using a clean dry cloth, wipe all the surfaces clean. DO NOT USE WATER! Never
WestonProducts.com
wash the Pasta Machine Attachment with water, place it in water, or put it into the
All Trademarks and Registered Trademarks are property of the respective companies.
dishwasher. Simply wipe it clean with a dry cloth.
.
SAVE THESE INSTRUCTIONS!
To clean the inner surfaces of the Pasta Machine Attachment pass a piece
Refer to them often and use them to instruct others.
of dough through the Cutters several times, making sure the dough touches all the
surfaces, especially the sides where machine oil can accumulate. Discard this dough
when finished.
FOR WARRANTY INFORMATION, Log onto
.
Use a dry pastry brush to remove any flour or bits of dough from the hard to reach
places.
.
Lightly sprinkle some flour on the Cutters. Using a dry brush, work the flour into
the edges of the Pasta Machine Attachment. Brush all the flour away and wipe the
machine clean again with a clean, dry cloth.
.
NEVER INSERT KNIVES BETWEEN THE CUTTERS!
|